EXPLOSION-FREE & SAFE

Betonamit® – The explosion-free demolition agent
Simple. Effective. Environmentally-Friendly

Betonamit type R (liquid)
Betonamit is an explosion-free demolition agent which enables relatively accurate demolitions without the need
for special conditions or equipment. It has a very good shelf life of at least 3 years. After a reaction time of only
a few hours Betonamit develops an enormous expansion pressure, which is soon so powerful that every hard rock
and even reinforced concrete is broken apart. Compared to other conventional demolition methods, Betonamit
works virtually silently, vibration-free and environmentally-friendly.

Betonamit type S (putty-like)
Betonamit Type S is used primarily for overhead work, as well as for horizontal or hard-to-reach drill holes.
The preparatory work and technical data for Betonamit type S corresponds to that of type R. The only and
definitive difference is that, after the mixing process, the Betonamit presents itself as a kneadable mass.
This mass is then shaped by hand into sausage forms and stuffed into the drill holes. Subsequently, these
sausage forms are each compressed with a stick, the diameter of which corresponds approximately to that
of the drill hole diameter.

Benefits of Betonamit

Simple and safe to use - also suitable for the DIY enthusiast!
Neither a demolition license nor other permits are required.
Free and professional advice.
Vibration-free, silent and without splitter flight.
A high-quality and tested product.
Useable in both indoor and outdoor areas.
Targeted demolition thanks to largely predictable crack formation.
Storable for at least 3 years in original packaging.

Technical Notices

> Only use drills with a diameter between 30mm and 40mm.
> The drill holes should be as clean and dry as possible.
> The minimum drill hole depth corresponds to 5 times the drill hole diameter.
> The maximum fillable drill hole depth is about 3 to 5 metres

DEMOLITION TIME TABLE

► Drill hole diameter 40mm

Ambient temperature	5 C°	10 C°	15 C°	20 C°	25 C°	30 C°	35 C°
Water temperature	25 C°	25 C°	20 C°	20 C°	20 C°	20 C°	20 C°
Drill Hole Spacing	40cm	40cm	40cm	40cm	40cm	40cm	40cm
Demolition Time	10-24 h	10-18 h	8-16 h	6-14 h	6-10 h	4-8 h	2-8 h

► Drill hole diameter 30mm

Ambient temperature	5 C°	10 C°	15 C°	20 C°	25 C°	30 C°	35 C°
Water temperature	25 C°	25 C°	20 C°	20 C°	20 C°	20 C°	20 C°
Drill Hole Spacing	30cm	30cm	30cm	30cm	30cm	30cm	30cm
Demolition Time	12-36 h	12-24 h	8-16 h	8-16 h	6-12 h	6-10 h	4-8 h

Tip! Betonamit continues to expand over several days. This means that the more time you give Betonamit to work, the easier the subsequent removal of the fragments will be. So, have some patience and let Betonamit do the really hard work for you.